WARNING: Brake pedal travel must not be restricted by additional floor coverings.

Notes: Grease all mountings before installation with grease Part No. G 000 602.

1. Mounting bracket
2. Self locking hexagon nut, Tighten to 30 Nm
3. Brake light switch

• Before installing, connect brake pedal to brake servo
• Before installing pull plunger out completely
• Push brake pedal down as far as possible by hand
• Guide through mounting hole (only fits in one position) and secure by turning 90ƒ clockwise
• Release brake pedal
• Connect brake pedal connector
• Check function of brake lights

4. Accelerator pedal
5. Hexagon bolt
6. Brake pedal
7. Pad
8. Self - locking hexagon nut, Tighten to 20 Nm
9. Mounting bush
10. Pivot pin