2001 Audi TT Quattro Roadster L4-1.8L Turbo (AMU)
Driver's Airbag Unit, Removing and Installing
Driver's Side Airbag Unit, Removing And Installing
CAUTION: Always read updated safety regulations for repair work on airbags.
|
1 |
- |
Steering wheel |
|
2 |
- |
Coil connector |
|
3 |
- |
Airbag unit |
|
4 |
- |
Multi-point socket head bolt |
- 60 Nm (44 ft lb)
- Must always be replaced
|
6 |
- |
Torx(R) key (T 30) |
|
7 |
- |
Coil connector with slip ring |
Removing
CAUTION: Observe safety precautions for performing repair work on airbags.
- Unbolt airbag unit using a T30 Torx(R) key.
- Disconnect connector - 2 -.
- Lay airbag down with the padded side upward.
Installing
- Make sure that connector 2 - engages audibly (click).
- Bolt on the airbag unit (7 Nm/62 in. lb ).
WARNING: Make sure no one is in vehicle when connecting battery.
- Switch ignition on and connect battery Ground (GND) strap.
NOTE:
- After connecting battery, check vehicle equipment (radio, clock, electric windows) as per Owner's Manual.
- If the Airbag Warning Light -K75- signals a malfunction after
assembling, then DTC memory must be erased and checked again using VAG
1551 scan tool.
